Most of us face the problem of leaky faucets at home. This is a common problem and it is often ignored. However, even an occasional drip from a leaky faucet will lead to considerable water wastage over time. For that reason, this kind of a problem should not be ignored. For those who are handy with simple plumbing tools and accessories might be able to address bathroom leak repairs of this kind by themselves. Usually there are different kinds of faucets and the fixes differ accordingly. Faucets can be of the following types:
• Ball type and cartridge.
• Ceramic disk.
• Compression.
The above categories of faucets are common these days and bathroom leak repairs of these faucets differ accordingly.
Starting work
For those who embark on repair work for leaky faucets need to first shut off the source of water supply. They need to close the drain of the sink by covering it with a rag. This will help to catch different dropped parts and make it easy to clean up afterwards. In order to avoid scratching any fixture, tape the wrench jaws with duct tape before you start. If there are mineral deposits on faucet parts, this might be a good time to clean them off with distilled white vinegar and a scouring pad.
Fixing different kinds of faucets
If there are water damage problems around shower units, you might need to look at leaking shower water proofing solutions. If you have to fix a compression type faucet, there are rubber washers around the valve seat. These washers tend to get worn out with time. Replacing them might help to address the leaking shower water proofing faucet issue. For other kinds of faucets which do not include washer component, you need to find the right cartridge to replace. For faucets which are ball type, ceramic disk based or cartridge based, these can be fixed by replacing the neoprene seal or O-ring. Replacing these accessory parts is not expensive. Once you have gathered the necessary parts proceed to replace the same. In case of compression faucets that leak, new seat washers would be required. You need to take off the decorative cap and remove as well as replacing the O-ring. In case of ball type faucets there are different parts and the right part to replace needs to be figured out. You could simply get a replacement kit and get the whole thing replaced. In case of a cartridge type faucet, you would want to replace the O-rings as well.
If working on the faucets is too much work, try calling in a plumber service. It might cost you but it will ensure that the leak is addressed right. If you do not know how to work with a wrench and change fixtures, it is best to leave the work to experts or professionals.
Visit us:-http://www.sealmastersact.com.au/
